Lounge chair reupholstery — a long leather settee and armchairs in a clubhouse lounge
Lounge chair reupholstery

A sofa that sags in the middle seats two.

Members will not take the dipped seat between two others. The sofa is still in the room, still upholstered, and the club has quietly lost a seat.

Count what you actually have

The lounge holds fewer members than the inventory says.

Walk the room at a busy hour and count the seats members choose. Lounge chair reupholstery starts from that number, not the one on the asset list, which is the same reason clubs track usable capacity through club benchmarking rather than inventory counts.

A leather settee whose middle seat sits visibly lower than the two beside it

The dipped middle

Lower than its neighbors, so it is taken last and only when the room is full.

The end seat of a club sofa, darker and more creased than the rest

The end everyone takes

An arm to lean on and a view of the door. It ages at twice the rate of the seat beside it.

A deep leather armchair with a collapsed seat cushion

The chair nobody rises from easily

Once the seat drops, older members avoid it. The chair is full but unused.

A settee by a clubhouse window with sun-faded leather along one end

The one in the sun

Faded along one end. Comfortable, but it makes the whole run look mismatched.

A settee photographed from the end, showing the middle seat sitting lower than the outer two Sagging springs and loose ties seen from under a club sofa seat A collapsed cushion filling removed from its leather cover on the bench
Why the middle goes first

No arm, no warning.

On the outer seats, members push down on an arm to stand. In the middle there is nothing to push on, so the whole load goes through the seat itself, twice per sitting.

  • Ties let go under the middle first, and the springs splay
  • The filling packs down and stops coming back overnight
  • The leather is often still sound, which is why nobody reports it
  • By the time it is obvious, the frame rail beneath is carrying the load
  • Fixed by rebuilding the seat, not by refinishing the hide
One settee, seat by seat

Three seats rebuilt, one cover.

The middle had dropped, the ends were sound, and the hide had years left in it: lounge chair reupholstery aimed at one seat.

  1. 01

    Sit in every seat

    Each seat tested and measured against the others, so the work is priced to what has actually gone.

    A settee with seat heights being measured during the walkthrough, tape resting on the seat
  2. 02

    Open the middle seat

    Only the failed seat is opened. The outer two keep their original build.

    The middle seat of a settee opened on the deck, hessian folded back
  3. 03

    Re-tie and re-pad

    Springs re-tied to the rails and new filling built to the height of the seats either side.

    Re-tied springs and fresh padding in a settee seat
  4. 04

    Cover the run together

    Where the hide is going, the whole run is recovered at once so no seat reads newer than its neighbors.

    New hide being fitted across a settee seat run on the bench
  5. 05

    Level, then back in the room

    The three seats sit at one height again, and the sofa seats three.

    The rebuilt settee back in the clubhouse lounge, seats level

Work runs through off-hours service and pickup and delivery, with a certificate of insurance to the club first.

What travels and what stays

Measure the doorway before promising anything.

Some club settees were carried in before the stairs were rebuilt around them, so lounge chair reupholstery starts with a tape measure.

PieceUsual jobWhere it happensRoom impact
Long setteesSeats rebuilt, run recoveredShop if the doorway allows; otherwise in the roomOne piece at a time
Two-seat setteesBoth seats, same visitShopOut and back in a batch
Lounge armchairsSeat and cushion rebuildShopIn pairs, so the room stays balanced
Loose cushionsNew filling in the existing coverCovers travel aloneNone: the frame stays in use
Ottomans and stoolsTop rebuilt and recoveredShopNone
Before / after

Level again, and the seat gets used.

More in the before and after gallery.

Before: a club settee with its middle seat sunk below the outer two
Before
After: the same settee with all three seats sitting level
After

Three-seat settee. Middle seat re-tied and re-padded, the run recovered together.

Before: a deep club armchair with a collapsed seat cushion
Before
After: the same armchair rebuilt, seat full and level
After

Lounge armchair. New filling to the original height, so members can get out of it again.

Related

Around the clubhouse.

Lounge chair reupholstery is one service on the private and country clubs hub, which plans the building room by room.

Questions

What clubs ask about the lounge.

Why does the middle seat always go first?

It has no arm to take weight as people sit and stand, so the load goes straight into the springs, and nobody notices until the seat has dropped below the two beside it.

Can you rebuild one seat rather than the whole sofa?

The springs and foam can be rebuilt seat by seat. The cover is another matter: a single recovered seat rarely matches the panels either side, so we usually recover the run together.

Does the sofa have to leave the room?

Cushions and loose seats travel on their own. A frame only leaves when the springs need re-tying, and we measure the doorway and stair turn before anything is promised.

How do you keep the room usable meanwhile?

One piece at a time, worked after hours, with the rest of the seating left in service. The room never loses all of its sofas at once.

What do you need to quote it?

Sit in the middle seat, then photograph the sofa from the front and from the end. That tells us whether it is a cushion job or a spring job.

A clubhouse lounge in the evening with an empty leather settee under lamplight
Start here

Sit in the middle seat, then send two photos.

One from the front, one from the end, where a dropped seat shows. That is enough to say whether the lounge chair reupholstery is a cushion job or a spring job. Or book a walkthrough.

Scroll to Top